Elite CSW200UL Spécifications télécharger pdf (Page 7)

UL LISTINGS AND INSTRUCTIONS

Install the gate operator only when:

The operator is intended for installation only on gates used for vehicles. Pedestrians

must be supplied with a separate access opening.

The gate must be installed in a location so that enough clearance is supplied between

the gate and adjacent structures when opening and closing to reduce the risk of

entrapment. Swinging gates shall not open into public access areas.

The gate must be properly installed and work freely in both directions prior to the

installation of the gate operator. Do not over-tighten the operator clutch to compensate

for a damaged gate.

Controls must be far enough from the gate so the user is prevented from coming in

contact with the gate while operating the controls. Controls intended to be used to reset

an operator after 2 sequential activations of the entrapment protection device or devices

must be located in the line of sight of the outdoor gate or easily accessible controls

shall have a security feature to prevent unauthorized use.

All warning signs and placards must be installed where visible in the area of the gate. A

minimum of two placards must be installed. A placard is to be installed in the area of

each side of the gate and be visible to persons located on the side of the gate on which

the placard is installed.

Installation Instructions regarding the CSW200UL™

The operator is appropriate for the construction and the usage class of the

gate.

All exposed pinch points are eliminated or guarded.

CSW200A Manual.qxd 12/9/04 3:11 PM Page 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 53 54

Pas de commentaire

Elite CSW200UL Spécifications Page 7