Elite B/W Manuel d'utilisateur télécharger pdf (Page 2)

LED

Board

Call

Button

Board

Call Button

Board

INSTALLATION FOR EL25

CAMERA MODULE MODELS EL25BWCAMKT,

EL25CCAMKT, AND EL25DVRCAMKT

1 Disconnect power to the unit.

2 Unlock and open the unit.

3 To remove the LED board, unplug the wire harness from LED

board and remove the screws (3). Do not remove the rubber

O-ring.

4 Replace black plastic lens with the clear lens. Keep rubber

O-ring in place.

5 Install the camera module. Reconnect the LED board wire

harness to the camera module.

6 Feed a coaxial cable (not provided) through the conduit hole

in the back mounting plate of the unit. Connect a BNC coaxial

connector to the back of the camera module.

7 Close and lock the unit.

8 Reconnect power to the unit.

LED

Board

Call Button

Board

100A

Wire Harness

Clear Plastic Lens

O-ring

Camera Module

Coaxial Cable

BNC Coaxial Connector

NOTE: If the EL25 is connected to a home entertainment system,

the home entertainment system must be switched to video input.

FOR VERTICALLY MOUNTED EL25 UNITS

The camera lens board must be repositioned 90 degrees

counterclockwise before the above steps can be performed.

When repositioning the camera board carefully remove and set

aside the 2 mounting screws.

“Portrait” positioning for vertical mounting

Rotated 90°

A static discharge can damage circuit boards.

1 2

Commentaires sur ces manuels

Pas de commentaire

Elite B/W Manuel d'utilisateur Page 2

Commentaires sur ces manuels