Elite CSW200UL Manuel d'utilisateur télécharger pdf (Page 2)

UL LISTINGS AND INSTRUCTIONS

INSTALLATION INSTRUCTIONS REGARDING THE GATE OPERATOR

A) Install the gate operator only when:

1) The operator is appropriate for the construction and the usage

Class of the gate.

2) All openings of a horizontal slide gate are guarded or

screened from the bottom of the gate to a minimum of 4 feet

(1.2 m) above the ground to prevent a 2 1/4inch (57.15 mm)

diameter sphere from passing through the openings

a n y w h e re in the gate, and in that portion of the adjacent

fence that the gate covers in the open position.

3) All exposed pinch points are eliminated or guarded, and

4) Guarding is supplied for exposed rollers.

B) The operator is intended for installation only on gates used for vehicles.

Pedestrians must be supplied with a separate access opening.

C) The gate must be installed in a location so that enough clearance is

supplied between the gate and adjacent structures when opening and

closing to reduce the risk of entrapment. Swinging gates shall not

open into public access areas.

D) The gate must be properly installed and work freely in both directions

prior to the installation of the gate operator.

E) -

F) C o n t rols must be far enough from the gate so that the user is

p revented from coming in contact with the gate while operating the

c o n t rols. Controls intended to be used to reset an operator after 2

sequential activations of the entrapment protection device or devices

must be located in the line of sight of the gate outdoor or easily

accessible controls shall have a security feature to prevent unauthorized use.

G) All warning signs and placards must be installed where visible in the

area of the gate.

1 2 3 4 5 6 7 ... 32 33

Pas de commentaire

Elite CSW200UL Manuel d'utilisateur Page 2